Lifegard AF-93 Individual Chemical Filter Module
Lifegard AF-93 Individual Chemical Filter Module
SKU:SKU AF-93
Lifegard AF-93 Chemical Module
14" High
Inlet: 1-1/4" Slip/ 3/4" FPT
Outlet: 1" Slip/ 3/4" FPT
Media Capacity: up to 7.3 oz.
Width: 7"
Depth: 4-3/4"
For Aquariums up to 100 gallons
Model Height Inlet Outlet Media Width Depth Aquarium Size* Single 14" H 1-1/4" Slip 1" Slip up to 7.3 oz. 7" 4-3/4" up to 100 gallons Double 23-3/4" H 1-1/4" Slip 1" Slip up to 15.6 oz. 7" 4-3/4" up to 200 gallons
Features:
How to Charge Chemical Chamber
-
Unscrew module cap.
-
Remove cup spring and chamber plug.
-
Remove chamber from module.
-
Fill chamber with coarse granular carbon or other media that will not pass through the chamber screen.
-
Rinse carbon by letting water run through open end of cartridge until water runs clear.
-
Install cartridge in filter module. Make sure cartridge fits onto center hub in bottom of filter module. Cartridge should protrude about 1/16" above module.
-
Replace cartridge plug.
-
Install cup spring (large end over cartridge plug).
-
Before replacing module cap, make sure O-Ring is clean and lubricated. Hand-tighten only.
How to Clean and Recharge the Filter
Shut off pump
Place clamps over inlet and outlet tubes below the level of the module cap
Remove the cap from module
Remove cup spring, chamber plug and chamber from module
Empty carbon or other media from chamber
Fill chamber with new carbon or other media. Make sure filtering media not pass through the chamber screen
Rinse carbon by letting water run through open end of cartridge until water runs clear
Before replacing module caps, remove the O-Ring and thoroughly clean it. Clean the O-Ring seat and all threads as well. Coat the O-Ring with silicone and replace cap on module and hand-tighten only
Remove clamp from inlet and outlet tubes and start pump